Minolta CD-10 - Manual (Page 25)

IBM/W
indows
23
Note: The following SCSI boards and ASPI managers can be
used by the CD-10 drive with IBM PC/AT compatible computers:
ASPI Manager: SCSI board:
ASPI2DOS.SYS AHA-1510A, AHA-1522A, APA-1460
ASPI4DOS.SYS AHA-1542CF
ASP7DOS.SYS AHA-2742-AT, AHA-2840A
ASPI8DOS.SYS AHA-2940
SCSI boards which use the AIC-7970 SCSI protocol chip
in standard mode.
The contents of the CONFIG.SYS file are as follows. Use
this for your installation.
(AHA-1542CF, EZ-SCSI V3.04, MS-DOS 6.20, and Win-
dows 3.1)
DEVICE=C:\SCSI\ASPI4DOS.SYS /D
DEVICE=C:\SCSI\ASPIDISK.SYS /D
DEVICE=C:\DOS\SETVER.EXE
DEVICE=C:\DOS\HIMEM.SYS
DOS=HIGH
DEVICE=C:\DOS\EMM386.EXE
FILES=30
STACKS=9,256
To replace the ASPIDISK.SYS driver
The attached ASPIDISK floppy disk stores the
ASPIDISK.SYS driver, which can read the data recorded on
a PC card. Copy this file into the directory in which EZ-
SCSI is installed.
(1) Insert the attached ASPIDISK floppy disk.
(2) Copy the ASPIDISK.SYS file stored in the ASPIDISK
floppy disk into the directory in which EZ-SCSI is in-
stalled.
(3) Remove the ASPIDISK floppy disk then restart the
computer.