MicroNet Technology SP5530 - Manual (Page 9)

- 6 -
2
H
ARDWARE
I
NSTALLATION
2.1. Attaching the Metal Clip
To attach the metal clip, remove the two rubber pads under the base of the
camera first. Place the metal clip onto the camera base and align the two holes of
metal clip with two screw holes on the camera base. Then, secure the metal clip
with two screws (provided in the package). There are two ears on each side of
the metal clip, allowing the camera to be mounted on the ceiling or wall using two
wall screws (provided in the package).
2.2. Connecting the Ethernet cable
Base of the camera
Wall screw
Screw
Ear
Ear
Connect an Ethernet cable to the
network cable connector located
on the camera’s rear panel and
then attach the other end to the
network.
Screw
Wall screw