MicroNet Technology SP3508A - Manual (Page 21)

Protocol Enable Setting
Parameter Description
Enable Spanning Tree
Protocol
Allow STP to be enabled.
Recommended setting is ‘enable’.
Enable Internet Group
Multicast Protocol
Allow IGMP to be enabled.
VLAN Protocol Allow selection of VLAN types. GVRP allows automatic VLAN
configuration between the VDSL Switch and nodes. If the switch is
connected to a device with GVRP enabled, users can send a GVRP
request using the VID of a VLAN defined on the switch, the switch
will automatically add that device to the existing VLAN.
Assign management IP
address to specific
VLAN
Can limit management system only for specific VLAN, This function
must enable 802.1Q.
Auto Speed SNR
margin value setup
VDSL Speed auto adaptive function is based on SNR value and
users can specify target SNR margins. Priority of Minimum setup is
higher than Maximum setup.
Maximum: When SNR value bigger than maximum value, VDSL
speed will increase.
Minimum: When SNR value smaller than minimum value, VDSL
speed will decrease.
18