Moxa Technologies 6110 - Manual (Page 15)

2-1
2 2
2.
Getting Started
This chapter includes:
❑ Power Connection
❑ Serial Installation
❑ Ethernet Installation
❑ Software Installation
❑ Housing
" DIN-Rail
" Wall Mount
Power Connection
Take the following steps to connect NPort 6110’s power adapter.
1. Plug the power adapter’s DC plug into NPort 6110’s DC-IN jack.
2. Plug the power adapter into an electrical outlet.
Note that there is no on/off switch. NPort 6110 automatically turns on when
plugged into the outlet, and the red PWR light on NPort 6110’s top panel will
glow to indicate that it is receiving power.
Serial Installation
NPort 6110 has one male DB9 serial port on the back panel. Depending on your
serial device and serial interfaces, there are two options:
1. You may use a DB9 to DB9 cable to connect your serial device to NPort
6110. Plug one end of the cable into the port on the back panel of NPort 6110
and plug the other end into your serial device’s serial port.
2. Refer to Chapter 8 for details of NPort 6110’s DB9 pinouts to make your
own serial interface cable.