Multiquip Light Tower Mount Type Balloon Light GB2000 - Manual (Page 7)

gb2000 balloon lighT• operaTion and parTs manual — rev. #3 (08/30/12)— page 7
safety infOrMatiOn
lighT ToWer saFeTy
danger
 never operate the equipment in an explosive
atmosphere or near combustible materials. An
explosion or fi re could result causing severe
bodily harm or even death.
Warning
 never disconnect any emergency or safety devices.
These devices are intended for operator safety.
Disconnection of these devices can cause severe injury,
bodily harm or even death. Disconnection of any of these
devices will void all warranties.
CauTion
 never lubricate components or attempt service on a
running machine.
 alWays ensure light tower is on level ground before use
so that it cannot slide or shift around, endangering workers.
Always keep immediate area free of bystanders.
 alWays make sure trailer is leveled with all outriggers
extended before raising tower. Outriggers must remain
extended while tower is up.
 alWays keep area behind trailer clear of people while
raising and lowering mast.
 never remove safety pin or pull mast locking pin while
tower is in a raised position!
 CheCK the mast and winch cables for wear. If any
problem occurs when lowering or raising the tower, STOP
immediately! Contact a trained technician for assistance.
 never pivot or retract mast while unit is operating.
 never use the light tower mast as a crane. do noT
lift anything with the mast.
 alWays lower the light tower when not in use, or if high
winds or electrical storms are expected.
NOTICE
 alWays keep the immediate area surrounding the light
tower clean, neat, and free of debris.
 alWays keep the machine in proper running condition.
 Fix damage to machine and replace any broken parts
immediately.
 alWays store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
 To prevent the light tower from overturning, never use
in winds that exceed 65 mph (105 km/h).
lamp saFeTy
Warning
 never attempt to replace lamp with the power on.
Always shut down the engine and turn off circuit breakers
when changing the lamp.
 alWays allow a suffi cient amount of time for the lamp to
cool before touching or changing. The possibility exists of
severe burns.
CauTion
 never use force when installing the lamp. Excessive force
could cause the lamp to break, causing bodily harm.
NOTICE
 never leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
 alWays make sure lamp surface is clean and dry.
 alWays replace with MQ recommended type lamp.
 alWays have a trained technician install and remove
a fl oodlight, or replace any damaged fi xture wiring.