Operation, Pump placement, Control box operation (manual mode) – Multiquip Submersible Pump ST4125G User Manual
Page 20: Figure 11. tilted position (incorrect)
PAGE 20 — ST4125G/ST6125G SUBMERSIBLE PUMP • OPERATION MANUAL — REV. #0 (11/18/10)
Pump Placement
1. Attach a suitable lifting chain to the eye bolts (Figure 10)
on the pump. Use a crane, or similar lifting device and
lower the pump into place. For applications where there
is an excessive amount of mud, grit or silt, the use of
a support platform is desirable.
Figure 10. Placing the Submersible Pump
(Correct Upright Position)
LIFTING
CHAIN
4 or 6-INCH
DISCHARGE
HOSE
POWER
CORD
SUPPORT
PLATFORM
CONNECT
TO CONTROL
BOX
LOWER
2. Make sure the pump is always placed in an upright
position, not tilted (Figure 11). Never position the pump
directly on a soft, loose bottom. To attain maximum
pumping capacity and prevent excessive wear, position
the pump so it will not burrow itself into sand or clay.
Figure 11. Tilted Position (Incorrect)
Control Box Operation (Manual Mode)
LOWER
OPERATION