Time out time, Busy channel lockout, Selecting transmit power – Midland Radio SYN-TECH III P25 User Manual
Page 33
Syn-Tech III P25 Portable Radio
OPERATION MANUAL
680-090-2040
Version 6.0
http://www.midlandradio.com
25
4.1.5.4 Time
Out
Time
A Time Out Time may be programmed to limit the
length of continuous transmissions. If the Time Out
Time is exceeded, release PTT and wait for the
channel to be available again. The Time Out Time
may be set from 15-240 seconds in radio
programming.
4.1.5.5
Busy Channel Lockout
The radio may be programmed to inhibit
transmission while the channel is busy. Wait
until the channel is clear before transmitting.
4.1.6
Selecting Transmit Power
For optimal battery life and to minimize
interference with others, use the lowest
transmit power that will provide
adequate range. The radio has three
transmit power levels which are
selected with successive presses of
the Power Change key (Default:
long press F1 button). The
actual transmit power associated with
each level is set in radio
programming.
Figure 4.16 – Transmit time out
Figure 4.17 – Busy channel lockout
Press
Power
Change key
to select
mid power
Press
Power
Change key
to select
low power
Figure 4.18 – Transmit power selection
Press
Power
Change key
to select
high power