Midland Radio SYN-TECH III P25 - Manual (Page 34)

Syn-Tech III P25 Portable Radio
OPERATION MANUAL
680-090-2040
Version 6.0
http://www.midlandradio.com
26
4.1.7 Selecting Digital Talk Group
The default talk group may be set
for the channel in radio
programming. When the channel
is selected, the default talk group
is used. If a default talk group was
not set for the channel, the radio
will use the talk group last
selected and displayed.
Each zone in the radio may have a
list of allowed talk groups or may
have all valid talk groups assigned
to it. When the radio is in digital
transmit mode, you may select a
new talk group from this list by
pressing the Talk Group Entry key
(default: star key) until
“TALKGROUP:” is displayed.
Then use the alpha-numeric
keypad to enter the new talk
group. Then press the left soft key (OK) to use the entered talk group. If the entered
talk group is not in the zone’s talk group list, the radio will not allow the talk group
selection.
If a talk group list has been created for the zone, a new talk group may also be selected
using the Group Up/Group Down keys. The zone’s talk group list may be viewed and a
new talk group may also be selected from MENU | CHANNEL PARAMETERS |
TALKGROUPS.
The radio has a talk group scan feature which is on by default. When a signal is
received from any talkgroup in the list, the radio will switch to the received talkgroup for
the duration of the receive signal and then start the scan delay timer. You may reply
using the received talk group during the scan delay time, by pressing PTT. After the
scan delay time expires the radio will switch back to the selected talk group. Use MENU
| CHANNEL PARAMETERS | TALKGROUP SCAN to turn talk group scan on/off.
Press
Group Entry
key
Enter new
talk group
then press
OK
Figure 4.19 – Group Entry talk group selection