Motorola POWERBROADBAND T2-2500 - Manual (Page 30)

VLANs
Motorola, Inc. 549453-001-00-a Page 30 of 51
Tag-based VLAN Mode Tag based mode is fully 802.1Q VLAN compliant. You must explicitly configure the
Egress and Ingress rules for each port and each VLAN. On the webUI, use the 802.1Q
TAG-BASED VLAN menu to configure VLANs.
The mT2 Switch and m2 WallPlate can operate independently. Be sure to configure all
ports on the Switch and the WallPlates for proper operation. Consult one of the VLAN
Tutorials.
Port-based VLAN Mode Port based VLAN is also called Port Isolation or Port Privacy in other switches.
When operating in port-based mode, the T2 Switch will ignore 802.1Q VLAN tags. Port
isolation is based on a VLAN Map. On the webUI, use the PORT-BASED menu to see
the VLAN Map and change the mapping. See below for more details.
Note:
The Switch operates in port-based mode; whereas the WallPlates only operate
in tag-based, or disabled. This allows for special case configurations where the
WallPlates do all the 802.1Q VLAN tagging, while the Switch maintains port-to-port
privacy.
V V L L A A N N c c o o m m m m a a n n d d s s i i n n m m T T 2 2
All VLAN configurations are also available from the webUI.
vlan config default
Restore VLAN configuration to default
vlan enable/disable Enable or disable VLAN support. Requires a system reboot after issuing this command.
vlan add Create or modify a VLAN.
vlan delete Delete a VLAN Group. Remove all ports that are members of the group before deleting
the group.
vlan name Enter a friendly name for the VLAN
vlan membership add Add or delete a VLAN from a port. Allows the VLAN to transmit on the port
vlan membership egress Sets how a VLAN will egress; with a tag or without. By default, packets will transmit
untagged unless specified using this command. Note this command does NOT apply to
WallPlate ports
vlan membership delete Deletes a port from a VLAN membership
vlan interface ingress Ingress command: Assign the PVID for a port. This VLAN ID will be assigned to all
packets received untagged on this port
vlan interface egress Set the Egress mode on any CPE port. This command does not apply to mT2 Switch
ports
vlan interface igmp Assign VLAN for IGMP packets
vlan interface mgmt Assign VLAN for layer 2 security for all management traffic
vlan mode Set the mode of operation on the Switch and the WallPlates. Options are IEEE 802.1Q
tag-based, or Port-based. Note: WallPlates only support tag-based or disabled.