Motorola POWERBROADBAND T2-2500 - Manual (Page 32)

VLANs
Motorola, Inc. 549453-001-00-a Page 32 of 51
Tag-based VLAN webUI
Create/Delete VLANs
Use this menu to create new VLANs and assign a
name to the VLAN. Note that you cannot delete
VLAN 1, however VLAN 1 can be removed from
all interfaces.
Set VLAN Egress Rules
Set the VLAN membership rules.
Click 3 times in the box to select (U)ntagged,
(T)agged or not a member. In this example, Eth1
is a (T)agged member of VLAN 50.
DSL ports will always be a (T)agged member of
any VLANs on the connected WallPlate
In this example, Port 1 of the first WallPlate is an
(U)ntagged member of VLAN 50.
Set VLAN Ingress Rules
Set the PVID for each port. This is also known as
the native VLAN for the port. All packets received
on these ports (as from a PC connected to the
port) are assigned the PVID of the port
Port-based VLAN webUI
When the local mode is set to Port-based (The mT2
Switch is the local mode), use the Port-based menu
to create a Port Map.
By default, Eth1 and Eth2 can communicate with
each other. All DSL ports can communicate with
Eth1 and Eth2, but NOT with each other.
The example at right shows an effective way to
configure port privacy on all DSL ports, and configure
Eth2 as a cascade port. This example can be
replicated on all Switches in a cascade for simple,
effective port privacy.
Note:
• Eth1 can communicate with Eth2
• Eth1 can communicate with all DSL ports
• Eth2 cannot communicate with all DSL ports
• DSL ports cannot communicate with each other