Motorola POWERBROADBAND T2-2500 - Manual (Page 4)

Motorola, Inc. 549453-001-00-a Page 4 of 51
IMPORTANT SAFETY INSTRUCTIONS
mT2a Switch
CAUTION: For installation only in a Restricted Access Location by trained service personnel.
CAUTION: Equipment must be connected to an earthed mains socket-outlet.
CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
CAUTION: The power supply cord plug serves as the main disconnect for the product. The socket-outlet shall be
installed near the product and be readily accessible.
CAUTION: Voltages present which are above TNV-3 (POTS) limits. A cover must be installed over the punch
down blocks with a HV (High Voltage) warning label (supplied).
The maximum operating ambient temperature is 50 degrees Celcius.
When installing the Switch in an equipment rack, consider the following potential hazards:
Elevated Operating Ambient Temperature – If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than the room ambient. Therefore, consideration
should be given to installing the equipment in an environment compatible with the manufacturer’s maximum rated
ambient temperature (Tmra).
Reduced Air Flow – Installation of the equipment in a rack should be such that the amount of air flow required for
safe operation of the equipment is not compromised.
Mechanical Loading – Mounting of the equipment in the rack should be such that a hazardous condition is not
achieved due to uneven mechanical loading.
Circuit Overloading – Consideration should be given to the connection of the equipment to the supply circuit and
the effect that overloading of circuits might have on overcurrent protection and supply wiring. Appropriate
consideration of equipment nameplate ratings should be used when addressing this concern.
Reliable Earthing – Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections to the branch circuit (e.g.,
use of power strips).
m2 WallPlate
CAUTION: Use only power supplies listed in the user manual
When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of
fire, electric shock and injury to persons, including the following:
1.
Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub,
in a wet basement or near a swimming pool.
2.
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning.
3. Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS