Netcommand, Initial setup, continued, Review screen – MITSUBISHI ELECTRIC WD-62628 User Manual

Page 44: Finish screen

Advertising
background image



Chapter 3. NetCommand Setup and Editing

Review Screen

Figure 6

After you have made your device choices, the Review

Screen will display. It is important to review the settings
to ensure that they are correct. If necessary, you can
use

<Back to return to the Device Setup screen to make

changes.

Figure 6. Review screen

Note: The Review screen lists the TV input and A/V
receiver input used with each device. You must
correctly identify the inputs you used when you
connected the devices. If you have not connected
your devices, write down these inputs as a guide. If
you cannot use these inputs, or if you would like to
change the name of a device, use the instructions in
Edit NetCommand to make necessary changes.

Note: If you select Next> on the Review screen, all
selections made are finalized.

On the Review screen, adding or deleting check marks
will turn the adjacent devices or inputs On or Off. 1394
device names only appear on the Review screen when
the devices are connected to the TV.

Finish Screen

Figure 7

To complete the NetCommand setup, select

Finish

from the Finish screen.

If you wish to change any of the pre- configured
inputs or names for the devices, or add devices not in
the pre-configured setup, select

Edit to display Edit

NetCommand menu.

If your A/V receiver was not listed, select

Edit to add

the AVR and then assign all devices to new AVR inputs.

Figure 7. Finish screen

It may still be necessary to memorize the available
channels for Antenna-1 (and Antenna-2, if used).
You may do that by going to the TV Main menu and
selecting Setup. Instructions to memorize channels are
found in the Setup menu section.

NetCommand

®

Initial Setup, continued

Advertising