Integra DHC-9.9 - Manual (Page 137)

137
Controlling Other Components
You can control your other components, including those
made by other manufacturers, with the remote controller.
This section explains how to:
• Enter the remote control code for a component that
you want to control: DVD, TV, VCR, etc.
• Learn commands directly from another component’s
remote controller (see page 140).
• Program the Macro buttons to perform a sequence of
up to eight remote control actions (see page 141).
To control another component, you must first enter that
component’s remote control code to a Remote Mode but-
ton. You’ll need to enter a code for each component that
you want to control.
Notes:
• Remote control codes cannot be entered for the
[Receiver], [Zone 2], and [Zone 3] Remote Mode but-
tons.
• The remote control codes provided are correct at the
time of printing but subject to change.
Entering Remote Control Codes
1 Look up the component’s remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
+
-
On Standby
TV
Input
TV CH
TV VOL
--/--- 10 11 12
D.TUN
+10 0 Clear
1 2 3
4 5 6
7 8 9
Input Selector
VCR/DVR CBL/SAT DVD
Tape Tuner CD
Phono
Game/TV
Macro
1 2 3
VCR DVD
CDR/MD
CD Zone 2
Remote Mode
Dimmer
Tape/AMP
Sleep
Receiver TV Dock Cable
VOL
CH
Disc
Album
+
-
Enter
Top
Men u Men
u
Display Muting
Exi t Gu ide
Prev
CH Ret urn Setu
p
RC- 691M
Audio Repeat Play Mode
Open/Close
Listening Mode
DVD HDD
Playlist Random Rec
Test Tone CH Sel
Direct
Stereo
Level+ Level-
L Night Audio Sel
THX All ST
Re-EQ
Subtitle
Video Off
VCR
Surround
SAT
Zone 3
AUX 1 AUX 2
Remote
Mode
TV
Receiver
Standby
I
Number
buttons
Remote
indicator
2 While holding down the Remote
Mode button to which you want
to enter the code, press the
[Standby] button.
The Remote indicator lights up.
3 Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
The Remote indicator flashes twice.
4 Press the Remote Mode button
again to select the remote con-
troller mode, point the remote
controller at the component, and
check the operation.
If the remote controller doesn’t work as
expected, and several remote codes are
listed, try each one in turn and use the
one that works best.
• The [DVD] and [CD] Remote Mode buttons are
preprogrammed for use with Integra/Onkyo DVD
players and CD players, respectively.
• To control another manufacturer’s CD recorder,
MD recorder or Onkyo RI Dock, enter the appro-
priate remote control code to the [CD] Remote
Mode button.