Integra DHC-9.9 - Manual (Page 22)

22
Connecting the AV Controller
The AV controller is designed to be used with a separate
multichannel power amplifier. You connect the AV con-
troller’s PRE OUT jacks to the amplifier’s inputs, and
connect your speakers to the amplifier’s speakers termi-
nals. Speaker settings such as crossover frequency and
distance are set on the AV controller.
Speaker Configuration
For 7.1-channel surround-sound playback, you need
seven speakers and a powered subwoofer.
The following table shows which channels you should
use based on the number of speakers you have.
* If you’re using only one surround back speaker, use the SURR
BACK L output.
No matter how many speakers you use, a powered sub-
woofer is recommended for a powerful and solid bass.
To get the best from your surround-sound system, you
must set the speaker settings. You can do this automati-
cally (see page 58) or manually (see page 104).
Using Dipole Speakers
You can use dipole speakers for the surround left and
right and surround back left and right speakers. Dipole
speakers output the same sound in two directions.
Dipole speakers typically have an arrow printed on them
to indicate how they should be positioned. The surround
left and right dipole speakers should be positioned so that
their arrows point toward your TV or screen, while the sur-
round back left and right dipolar speakers should be posi-
tioned so that their arrows point toward each other, as
shown.
Connecting Your Speakers
Number of speakers: 2 3 4 5 6 7
Front left ✓ ✓ ✓ ✓ ✓ ✓
Front right ✓ ✓ ✓ ✓ ✓ ✓
Center ✓ ✓ ✓ ✓
Surround left ✓ ✓ ✓ ✓
Surround right ✓ ✓ ✓ ✓
Surround back* ✓
Surround back left ✓
Surround back right ✓
2
1
3 4 2
1
3 4
5 6
7 8
5
7 8
6
TV/screen TV/screen
1. Subwoofer
2. Front left speaker
3. Center speaker
4. Front right speaker
5. Surround left speaker 6. Surround right speaker
7. Surround back left
speaker
8. Surround back right
speaker
Dipole speakers Normal speakers