Integra DHC-9.9 - Manual (Page 43)

43
Connecting the AV Controller
—Continued
■ If Your iPod Supports Video:
Connect your RI Dock’s audio output jacks to the
AV controller’s AUX 1 IN L/R jacks, and connect its
video output jack to the AV controller’s AUX 1 IN V
jack.
(Onkyo DS-A2X hookup shown below.)
■ If Your iPod Doesn’t Support Video:
Connect your RI Dock’s audio output jacks to the
AV controller’s AUX 1 IN L/R jacks.
(Onkyo DS-A2X hookup shown below.)
■ If you have an Onkyo DS-A1 RI Dock
• Connect its video output jack to the AV controller’s AUX 1 jack.
The AV controller has AC outlet on its rear panel that can be used to
connect the power cords of other components that you intend to use
with the AV controller. These components can then be left turned on
so that they turn on and off as and when the AV controller is set to On
or Standby.
Caution:
• Make sure that the total capacity of the components that you con-
nect to the AC OUTLET does not exceed the stated capacity.
Notes:
• When the “HDMI Control” setting is set to “Enable” (page 126),
the AC outlet are on all the time regardless of whether the AV con-
troller is set to On or Standby, or Ready mode in this case, so any
components connected to them cannot be turned on or off automat-
ically.
• Integra/Onkyo components connected via should be connected
directly to a wall outlet, not an AC OUTLET on the AV controller.
Connecting an RI Dock
Not all iPod models output video. For information
about which iPod models are supported by the RI
Dock, see the RI Dock’s instruction manual.
L
R
IN
V
L
R
IN
Notes:
• Connect the RI Dock to the AV controller with an
cable (see page 44).
• Set the RI Dock’s RI MODE switch to “HDD” or “HDD/DOCK”.
• Set the AV controller’s Input Display to “DOCK” (see page 57).
• By using the [Dock] Remote Mode button on the remote controller of the AV controller to change the remote
mode to “DOCK”, you can operate your iPod in the RI Dock (see page 20).
If you cannot operate it, you will need to enter the appropriate remote control code (see page 137).
• See the RI Dock’s instruction manual for more information.
Connecting the Power Cords of Other Components (North American model only)
AC OUTLET
AC 120V
SWITCHED
120W 1A MAX.
60Hz
North American model