Integra DTR-5.3 - Manual (Page 13)

13
Remote controller
INPUT SELECTOR buttons [43, 44, 52]
Press to select an input source.
Same as the input selector buttons on the front panel of the DTR-6.3/
5.3. The input source for each button is given here. DVD:DVD,
CD:CD, V1:VIDEO1, V2:VIDEO2, V3:VIDEO3, V4:VIDEO4,
V5:VIDEO5 (not used with the DTR-6.3/5.3), TAP:TAPE,
TUN:FM/AM, PH:PHONO (not used with the DTR-5.3).
Numeric key/Listening mode, SP A, SP B, CINE
FLTR, Display, Dimmer buttons
1 to 9, +10, --/---, 0: For entering the number of a track. [63–65]
Pure A:
DTR-5.3: Not used with the DTR-5.3.
DTR-6.3: Press to select the Pure Audio mode. [50]
Direct, Stereo, SURR, All ST, DSP: You can select a listening
mode. [50]
Note:
During playback of a multichannel source, press the Direct button to
turn off the tone control and the SURR button to turn on the tone
control. [47]
SP A, SP B:
DTR-5.3: Switches between speakers A and B. [44]
DTR-6.3: Not used with the DTR-6.3.
CINE FLTR: Depending on the listening mode, you can turn the
CinemaFILTER function on or off. [51]
Display: For changing the display in the front display. [47]
Dimmer: Adjusts the display brightness.
There are three settings available: normal, dark, and very dark.
Light button
Press to turn on and off the lights in the buttons of the remote
controller.
Setup button [37]
Press to display the Setup Menu on the TV screen and in the display.
Press again to exit the menu.
/ / / , ENTER button [37]
When in the Setup Menu, press the upper and lower arrow buttons to
select an item, press the right and left arrow buttons to select
parameter values or modes, and press the ENTER button to advance
to the next item.
VOL button [43, 44]
Press to adjust the volume.
Test/Menu button
This button is used to set the speaker output levels. Use this button in
conjunction with the Level / and CH SEL buttons to calibrate the
speakers levels without entering the Setup Menu. [40]
When the DVD mode is selected, press to display the DVD menu
(Menu). [64]
Muting button [47]
Press to activate the mute function.
Zone 2/Search/Enter button
When the DVD mode is selected, press to find the specific section
on a DVD where you want to start playback (Search). [64]
DTR-6.3: When in the RCVR mode, press to perform operations
on the remote zone (Zone 2). [59]
DTR-5.3: Switches the audio signal output to the A-BUS
keypad. [28]
When in the MD mode, press to enter the selected song (Enter). [65]