Integra DTR-5.3 - Manual (Page 64)

64
Using remote controller
Controlling an Integra/Onkyo DVD player
The connector of the Integra/Onkyo DVD player must be
connected to the DTR-6.3/5.3 (see page 29).
1. Press the DVD Mode button.
The DVD Mode button lights green.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Integra/Onkyo DVD
player.
Operation buttons:
On: Turns DVD player on and off
Standby: Turns DVD player off (Some sets may not respond to this
button. In this case, use the On button to put the DVD player in the
standby state.)
Setup: Displays OSD Menu of the DVD player
: Moves cursor in the OSD Menu of the DVD player
ENTER: Enter button for the OSD Menu of the DVD player
Return: Return button for the OSD Menu of the DVD player
Top Menu or Menu: Displays menu screens recorded on DVD
media
Disc : Selects disc in DVD changer
Audio SEL: Selects audio or language track (if recorded on the
DVD)
Angle: Selects camera angle (if recorded on the DVD)
Subtitle: Selects subtitle language (if recorded on the DVD)
Search: Searches for location on disc to start playback
Random: Random playback
: Chapter/Track down
: Chapter/Track up
: Play
: Stop
: Fast reverse
: Fast forward
: Pause
: Opens/closes disc tray
0, 1 to 9, +10: Numeric keys
You may also use the following buttons:
VOL : Adjusts volume at DTR-6.3/5.3
Muting: Activates muting function at DTR-6.3/5.3
Note:
When operating an Integra/Onkyo DVD player directly with the
remote controller without connecting the
terminals, pre-
programming is necessary (see page 66).
VOL
Muting
On Standby
DVD Mode
Subtitle
DVD
operation
buttons
Top Menu
Return
Audio SEL
Angle
ENTER,
Search
Numeric keys
Setup
Menu
DISC