Integra DTR-5.3 - Manual (Page 38)

38
Configuring the speakers
4. Use the and cursor buttons to select “Subwoofer”
and then use the and cursor buttons to select the
subwoofer setting.
Yes: Select when a subwoofer is connected.
No: Select when a subwoofer is not connected.
5. Use the and cursor buttons to select “Front” and
then use the and cursor buttons to select the front
speaker setting.
Large: Select if the front speakers are large sized.
Small: Select if the front speakers are small sized.
• If “No” is selected for the Subwoofer setting, this setting is
fixed to “Large.”
6. Use the and cursor buttons to select “Center” and
then use the and cursor buttons to select the
center speaker setting.
None: Select if no center speaker is connected.
Large: Select if the center speaker is large sized.
Small: Select if the center speaker is small sized.
• If “Small” is selected for the Front setting, “Large” cannot be
selected for this setting.
7. Use the and cursor buttons to select “Surround”
and then use the and cursor buttons to select the
surround speaker setting.
None: Select if no surround left and right speakers are
connected.
Large: Select if the surround left and right speakers are large sized.
Small: Select if the surround left and right speakers are small sized.
• If “Small” is selected for the Front setting, “Large” cannot be
selected for this setting.
8. Use the and cursor buttons to select “Surround
back” and then use the and cursor buttons to
select the surround back speaker setting.
None: Select if no surround back speaker is connected.
Large: Select if the surround back speaker is large sized.
Small: Select if the surround back speaker is small sized.
• If “None” is selected for the Surround setting, this setting will
not appear.
• If “Small” is selected for the Surround setting, “Large” cannot
be selected for this setting.
9. Use the and cursor buttons to select “Crossover”
and then use the and cursor buttons to select the
crossover frequency mode setting.
Adjustable Crossover (80/100/120 Hz) for Bass Management
This setting allows you to set the crossover frequency for your
speaker system. This setting is valid when “Subwoofer” is set to
“Yes,” or for speakers that are set to “Small,” at the “Speaker
Config” menu. The crossover frequency is the minimum
frequency delivered to a speaker and can be set to 80 Hz, 100 Hz,
or 120 Hz. Frequencies below this are cut from speakers set to
“Small” and sent to the subwoofer (or to speakers set to
“Large”).
Press the Return button to return to the main menu.
Press the Menu button on the front panel or Setup button on the
remote controller to exit the Setup menu.
Remote controller DTR-6.3/5.3