Integra DTR-5.3 - Manual (Page 71)

71
Programming the commands of remote controllers for other devices into the remote
controller
Erasing the programmed command from one
button
You can only erase memorized commands and not preset ones.
1. Press and hold down the Mode button for the command,
press the Enter button, and then release both buttons.
When you press the Mode button, the Send/Learn indicator
lights. When you press the Enter button, the lamp turns off.
When you release the buttons, the lamp lights again.
2. Press and release the button for the command you
wish to erase.
When you press the button, the Send/Learn indicator turns off.
When you release the button, the lamp lights again.
3. Press and release the same button again.
The Send/Learn indicator slowly flashes twice. The memorized
command is erased.
Note:
If the Send/Learn indicator quickly flashes three times and turns off,
then the remote controller has exited the erasing mode because either
you have made a mistake during erasing or a time-out has occurred
because no button has been pressed. Resume from Step 1.
Erasing all the commands programmed under a
Mode button
1. Press and hold down the desired Mode button, press
the Enter button twice, and then release both buttons.
When you press the Mode button, the Send/Learn indicator
lights. When you press the Enter button, the lamp turns off.
When you release the buttons, the lamp slowly flashes twice and
then lights again.
2. Press and release the same Mode button again.
When you release the button, the Send/Learn indicator slowly
flashes twice. This erases all the commands memorized to the
Mode button.
Notes:
• If the Send/Learn indicator quickly flashes three times and turns
off, then the remote controller has exited the erasing mode
because either you have made a mistake during erasing or a time-
out has occurred because no button has been pressed. Resume
from Step 1.
• If many commands have been programmed to the Mode button,
then the Send/Learn indicator may remain lit for up to 20
seconds during Step 2. This is not a malfunction.
Enter
Send/Learn
indicator
Mode buttons
Enter
Mode buttons
Send/Learn
indicator