Inova PD00941013.001 - Manual (Page 62)

©2004 Inova Computers GmbH Page A-4 ICP-PM/CM Appendix-A
ICP-HD-3 Appendix A
Table A1.2 Interface Description of the ICP-HD-3(-ND) Module
The accessibility / maintainability of the mounted hard disk is ensured through the two fixing
screw cutouts on the carrier board. A mounted hard disk is thus unable to shift or become dis-
lodged in any direction.
Note:
Any notebook-style IDE hard disk,
Flash device or similar mass-storage
unit can be connected here. However,
Inova recommend only those devices
from known manufacturers.
Connecting devices to both J9 and J12
simultaneously is not recommended. A
better configuration is to use Master
and Slave devices connected to J12
only or use the Rear I/O feature.
Connector Description
Open: COM1 is configured for RS232 communication
Closed: COM1 is configured for RS485 communication
Open: COM2 is configured for RS232 communication
Closed: COM2 is configured for RS485 communication
J3 COM2 physical interface
J4 Reset - shorting these pins causes the CPU to reset
J5 PS-2 mouse & keyboard physical interface
J6 USB 2.0 physical interface - USB2
J7 COM1 physical interface
J8 Slim-line floppy disk interface
J9 Notebook style 2.5" IDE header for HD or Flash etc.
Open: The CompactFlash on the CPU is Master
Closed: The CompactFlash on the CPU is Slave
J11 Flex cable interface for LPT1 (IPB-FPE12) module
J12 Standard 3.5" EIDE interface [80-strand cable only!]
J15 USB 2.0 physical interface - USB3
J1
J2
J10