Innotek Automatic No-bark Collar BC-50E - Manual (Page 2)

Intended Use
INNOTEK No-bark Collars (Models BC-50E and BC-200E) are designed for use in European countries: AT, BE,
CH, DE, DK, ES, FI, FR, GB, GR, IE, IS, IT, LU, NL, NO, PT & SE.
This product is in full compliance with the provisions of the R&TTE – Directive 1999/05/EEC. The Declaration
of Conformity can be found at: http://www.innotek.net/world.shtml
Caution for Battery Use:
• Do not disassemble
• Do not short circuit
• Do not expose to high temperature: 60°C/140°F
• Do not incinerate
• Avoid high humidity
• Keep batteries out of reach of children
Batteries must be recycled or disposed of properly. They should NEVER be placed in municipal
waste. Should it necessary to remove or replace your unit's battery, your INNOTEK Service Center
will dispose of it according to local regulations.
COMPONENTS
Before you begin, please take a few moments to become familiar with the basic components and their
functions.
A. Collar Unit - Attached to a collar strap, this small box contains the circuitry that delivers the stimulation to
your dog.
• BC-200E (Battery rechargeable) -- This rugged, waterproof collar unit contains a long-life, rechargeable
battery. It has some charge from the factory; however, you should fully charge the unit before the initial
use.
• BC-50E (Replaceable battery) – This water- resistant collar
receiver is powered by a 6-volt alkaline battery.
B. Stimulation Probes -The probes sense the vibration from the
dog's vocal cords and deliver stimulation. Two sets of probes
are included so you can use the collar with dogs of varying coat
lengths. This unique two-probe design is an INNOTEK-exclusive.
C. 6-volt alkaline battery (BC-50E only) - the power source for the
battery replaceable unit.
2
A.
B.
D.
C.
E.
2100244-2_bc-50_200e.qxp 11/11/2005 9:31 AM Page 2