Insignia NS-HT511 - Manual (Page 8)

4
Insignia NS-HT511 Home Theater System
www.insigniaproducts.com
Display
Back
Subwoofer
# Indicator
1 Audio input indicator
2 Listening mode indicator
3 Tuning indicators
4 SLEEP indicator
5 MUTING indicator
6 DIGITAL display
# Description Function
1 DIGITAL IN jacks Plug the optical digital cable from a game (1) or
TV/CD (2) into the upper jacks, or the coaxial
digital cable from a BD/DVD into the lower jack.
2 HDMI jacks Plug the HDMI signal input cable from a GAME
(IN4), CBL/SAT (IN3), VCR/DVR (IN2), BD/DVD
(IN1).
Plug the HDMI output signal cable to a TV or
monitor into the OUT jack.
3 ANTENNA connectors Connect a 75 ohm FM antenna to the coaxial
connector or an AM loop antenna to the wire
connectors.
4 FRONT SPEAKERS
SURROUND SPEAKERS
CENTER SPEAKER Connect the front speakers to these jacks.
Connect the left and right surround speakers and
the center speaker to these connectors. If you use
the RF-RBCARD to connect your surround speakers,
do not connect them here.
5 AC power cord Plug this cord into an AC power outlet.
6 COMPONENT video jacks Plug the cables from a component video source
into the #1 (BD/DVD) or #2 (CBL/SAT) jacks.
Plug the cables to a component video monitor into
the OUT jacks.
The jacks are color coded (red, green, and blue) to
correspond to the cable connectors.
7 Composite Video and
Audio L/R jacks Plug the composite video and audio L/R output
cables from the indicated devices into these jacks.
For video recording, plug the composite video and
audio L/R input cables to a VCR or DVR into the
OUT jacks
8 MONITOR OUT V (Video) Connect this jack to a TV monitor.
9 SUBWOOFER Connect the subwoofer to this jack.
# Description Function
1 Standby/On indicator Red: Subwoofer in standby mode
Blue: Subwoofer on
With the auto standby function, the subwoofer
automatically turns on when an input signal is
detected in standby mode. When there is no
input signal, the subwoofer automatically
enters standby mode.
Note: The auto standby function turns the subwoofer
on when the input signal exceeds a certain level. If the
auto standby function does not work reliably, try
slightly increasing or decreasing the subwoofer output
level on the receiver
2 OUTPUT LEVEL control This control is used to adjust the volume of the
subwoofer.
3 LINE INPUT jack This jack should be connected to the subwoofer
pre-out on the AV receiver with the supplied
RCA cable.
Front
Back
NS-HT511_11-0310_MAN_.book Page 4 Wednesday, April 13, 2011 11:12 PM