Interlink electronic L485SIB - Manual (Page 7)

7
www.ultrachefgrills.com
Lights Left Burner
Side Burner
Right Burner Centre Burner
Lighting Instructions
Off Position
Rear Burner Side Burner Igniter
WARNING!
Open lid
WARNING!
Ensure all burner controls are in the off position. Turn on the gas supply valve.
Main Tube Burner
Lighting
Rear Burner Lighting
(If equipped)
Side Burner Lighting
(If equipped)
1. Open grill lid. 1. Open grill lid. 1. Open/Remove side burner cover.
2. Push and turn any main burner
knob slowly to the ’hi’ position. This
action will ignite the pilot flame which
will in turn light the selected burner. If
the pilot lights, continue to push down
on the control knob until the burner
lights and then release.
2. Remove the warming rack 2. Push and turn side burner control
to high position.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the ‘off position and repeat
step 1 several times.
.
3. Clip a match into the supplied
lighting rod. Hold a lit match to
right end ports of rear burner. Turn
rear burner to high.
3. Press and hold
igniter button until burner lights, or
light by match
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the ‘off’ position and
wait 5 minutes for any excess gas to
dissipate. Either repeat steps 1 and 2
or light with a match.
4. If the burner will not ignite within
5 seconds, turn the control knob to
the ‘off’ position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
match.
WARNING!
The propane cylinder is equipped with an excess flow device. Unless all burners
are turned off prior to turning the cylinder on, only small flames and low heat will
be achievable.
WARNING!
Do not use the rear burner (rotisserie burner) with the main burners operating.
WARNING!
If lighting the unit with a match, clip the match into the supplied lighting rod.
Hold the lit match down through the grill and sear plate while turning the
corresponding burner valve to high.