Icom DSC CONTROLLER DS-100 - Manual (Page 23)

4
SET-UP
19
■ Offset time
Local time can be used when
the GPS position data is valid
and off set time is input.
q Push [CALL], then push [ √ ]
one or more times to select
‘Set-up’, then push [ENT].
w Select ‘Offset time’, then
push [ENT].
e Push “0; –” or “1; space”, then input the time differences.
r Push [ENT] to determine the time or push [CLR] to exit the
Set-up menu.
■ Brightness
• Adjusting the brightness
q Push [CALL], then push [ √ ] one or more times to select
‘Set-up’, then push [ENT].
w Select ‘Brightness’, then push [ENT].
e Push [ Y ] or [ Z ] one or more times (or numeral keys in-
stead) to adjust the brightness.
• Brightness level indication; 1 (dark) to 8 (bright)
r Push [ENT] to determine the brightness or push [CLR] to
exit the Set-up menu.
■ Contrast
• Adjusting the contrast
q Push [CALL], then push [ √ ] one or more times to select
‘Set-up’, then push [ENT].
w Select ‘Contrast’, then push [ENT].
e Push [ Y ] or [ Z ] one or more times (or numeral keys in-
stead) to adjust the contrast.
• Contrast level indication; 1 (low) to 8 (high)
r Push [ENT] to determine the brightness or push [CLR] to
exit the Set-up menu.
■ MMSI check
Your ID code can be displayed via the set-up menu.
• Check your ID
q Push [CALL], then push [ √ ] one or more times to select
‘Set-up’, then push [ENT].
w Select ‘MMSI check’, then
push [ENT].
e Your ID code shows on the
display.
r Push [CLR] to exit the Set-up
menu.
<MMSI check>
267350012
<CLR"Exit>
<Offset time>
—09:30
<CLR➝Exit / ENT➝OK>