Insignia NS-R5101 - Manual (Page 24)

24
Insignia NS-R5101 5.1 Surround Sound A/V Receiver
www.insignia-products.com
Using your receiver
After connecting power for the first time, set
up your receiver for optimum performance by
following the instructions in “Modifying the
settings” on page 17.
Using your receiver
To use your receiver:
1 Press the POWER button on
the receiver to put the receiver
in Standby mode. The
STANDBY indicator lights up.
2 Press the POWER ON button on the remote
control to turn the receiver on.
3 Turn on and begin playing the component for
playback.
4 Press an Input Selector button to select the
input source.
Tip
The following settings are stored in memory
before the receiver is turned off:
•
INPUT SELECTOR settings
• Surround mode settings
• Preset stations.
Tip
You can turn the receiver off by pressing the
POWER button on the receiver while it is in
Standby mode.
Tips
• You can put the receiver in Standby mode by
pressing the STANDBY button on the remote
control when the receiver is on.
• With the receiver in Standby mode, you can
also turn the power on by pressing an Input
Selector button.
• If you do not hear sound from the speakers,
press the SPEAKER button to turn the
speakers on. The SPEAKER indicator lights up
and sound can be heard from the speakers.
Press the SPEAKER button again to turn the
headphones on and the speakers off.
Notes
• When listening to a DTS or Dolby Digital
program source, if the headphones are
plugged in and the SPEAKER button is set to
off, the receiver enters the 2CH downmix mode
automatically. For more information, see “2CH
downmix mode” on page 27.
• When EXTERNAL IN is selected as an input
source, only front left and front right channel
signals can be reproduced through the
headphones.
Note
When playing back a program source with
surround sound, refer to “Enjoying surround
sound” on page 26.
PRESETS
Note
Each time the VIDEO button is pressed, the input
source changes as follows:
•
VIDEO1
• VIDEO2
• VIDEO3
Note
Each time the AUDIO button is pressed, the input
source changes as follows:
•
CD
• AUX
• TAPE
Note
Each time the FM/AM button is pressed, the band
changes as follows:
•
FM ST
• FM MONO
• AM
Notes
• If you press EXTERNAL IN on the receiver or
EXT IN on the remote control, EXT IN appears
on the display and six separate analog signals
from the component connected to this input
pass through the tone and volume circuits and
can be heard from the speakers.
• These analog signals can be heard only. They
cannot be recorded.
• To cancel this function, press a different input
source button.
OR
OR