Intel SR1500AL - Manual (Page 75)

Intel
®
Server System SR1500AL User’s Guide 53
10. Install the PCI riser assembly into the server system. For instructions, see
“Installing the PCI Riser Assembly” .
11. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct” .
12. Install the server system cover. For instructions, see “Installing the System Cover” .
13. Plug all peripheral devices and the AC power cable(s) into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover” .
4. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” .
5. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” .
6. Open the rear retention clip by pushing the blue slide upward and rotating clip to
the fully open position (see letter “A”).
7. Remove the PCI add-in card from the riser card connector (see letter “B”).
Figure 43. Removing a Full Height Add-In Card
8. Close both retention clips.
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCI riser assembly into the server system. For instructions, see
“Installing the PCI Riser Assembly” .
AF000362
A
B