Intel SR1500AL - Manual (Page 81)

Intel
®
Server System SR1500AL User’s Guide 59
6. Loosen the captive screw on the backplane board (see letter “A” in the figure
below).
7. Hold the backplane board only by the edges. Slide the backplane board to the right
to release it (see letter “B” in the figure below).
8. Lift the backplane board over the retention pins (see letter “C” in the figure below)
and out of the server system (see letter “D” in the figure below).
Figure 49. Removing the Backplane from the Server System
Installing the Backplane Board
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information” .
2. Power down the server and unplug all peripheral devices and the AC power
cable(s).
3. Remove the server system cover. For instructions, see “Removing the System
Cover” .
4. Lower the backplane board into the system (see letter “A” in the figure below) and
position the backplane board over the retention pins as shown (see letter “B”).
5. Slide the backplane board to the left (see letter “C”) to lock it in place and tighten
the captive screw (see letter “D”).
D
AF000370
A
B
C