Initio I/O HIGHWAY - Manual (Page 31)

27
initio
®
New Windows 95B (OSR2) Installation
These instructions will guide you through the installation of the Initio host adapter driver
while installing Windows 95B (OSR2). Windows 95B will be installed from either a CD-
ROM or floppy diskettes. It is important that the hardware and DOS 4.01 or higher have
been installed successfully before proceeding further. If installing from a SCSI CD-ROM
drive, it is important that the Initio ASPI driver, and CD-ROM driver be installed before
proceeding further.
1 Access the Windows 95B CD-ROM either from the DOS prompt or from Microsoft Win-
dows 3.x File Manager. Execute the SETUP.EXE program and follow the instructions on
your screen. If you are installing from floppy diskette, insert the Windows 95 Setup Disk
1 in your floppy disk drive and boot your system. Follow the instructions on your
screen.
2 Once a Windows 95 session is established, use your installed mouse or the appropri-
ate key strokes to select MY COMPUTER from the MAIN DESKTOP. Execute the
following steps:
• Select CONTROL PANEL from within the MY COMPUTER group
• Select SYSTEM from within the CONTROL PANEL group,
• Select DEVICE MANAGER tab from within the SYSTEM group
• Select the OTHER DEVICES category from within the DEVICE MANAGER listing
• Select one of the PCI-SCSI Bus Controller sub-category from within the OTHER
DEVICES listing
• In the Initio PCI-SCSI Bus Controller Properties window, select the DRIVER tab,
then select “UPDATE DRIVER...”
• Insert INI-9XXXU/9XXXUW DRIVER DISK 1 into drive A:
• Select YES, click Next, and Windows will search for the driver
• Select the OTHER LOCATION
• Type A:\WIN95, then select “OK”
• Select “FINISH”
• At window “Insert Disk labled INI-9XXXU/9XXXUW driver” , select “OK”
• At window titled “Copying file”, replace the highlighted directory path with
A:\WIN95, then select “OK” this will complete loading the INI910U.MPD driver
onto your hard disk drive.
3 Following installation of the Initio INI-9XXXU/UW Windows 95 driver, reboot your sys-
tem to activate the SCSI device driver.
Microsoft Windows 95/95b (OSR2) Driver Installation