Initio I/O HIGHWAY - Manual (Page 38)

34
initio
®
2 When SETUP begins to load, the screen will turn from black to blue with the text
“SETUP IS INSPECTING YOUR COMPUTER’S HARDWARE CONFIGURATION ” at the
top
• Press the F6 key to interrupt this process. You will have two seconds in which to
press this key
• Follow the instructions on the screen until you are asked to specify a SCSI driver.
3 Insert the INI-9XXXU/9XXXUW DRIVER DISK 1 into your local floppy disk drive,
and press <ENTER>.
• Select: Initio INI-9XXXU/UW PCI SCSI Host Adapter
4 The Initio host adapter driver is now installed
The on-screen instructions will continue for a complete installation of Windows NT.
Refer to your Windows NT System Administrator’s Guide for completion of the operating
system installation procedure.
Installing a new Windows NT system from a Bootable CD
For computer systems installing or upgrading to Windows NT from a bootable CD, these
instructions will guide you through the INI-9XXXU/9XXXUW host adapter driver installa-
tion. The Windows NT driver will be found on the INI-9XXXU/9XXXUW DRIVER DISK 1 .
It is important that the hardware has been installed successfully before proceeding
further.
1 Boot your system from a Windows NT CD.
2 When initial boot screen (Black and white screen prior to blue screen) shows the
message, “Setup is inspecting your computers hardware configuration,” press F6.
3 A setup screen will appear asking which drivers you wish to use.
4 Press the appropriate key to add driver and select other.
5 Windows NT will prompt you for a manufacturer’s supplied disk.
6 Insert the Initio manager set floppy (marked
INI-9XXXU/9XXXUW DRIVER DISK 1) and
press ENTER. The host adapter should be recognized by Windows NT and the driver
will be allowed to load. The operating system will continue loading and should
recognize the hard drives.
Microsoft Windows NT Driver Installation