ILY Enterprise CoolCopy 7 - Manual (Page 9)

Copyright ©2005 by ILY Enterprise Inc.
All Rights Reserved.
9
Chapter 3 Key Functions and Operating Instruction
1. LCD Display Panel: Display main functions and all messages.
2. Scroll up through menus or functions.
3. Scroll down through menus or functions.
4. Execute the function which you select.
5. Cancel the function which you select.
After turning the power on, the Coolcopy CD Duplicator will execute a self test for a few seconds.
After the self testing procedure runs, the LCD will show:
1. Coolcopy3: Coolcopy7:
2.
3.
4.
Two main operation procedures
If you install a 3.5” hard disc, the operation procedures is as follows:
1. With hard drive installed
• Once duplicator detects a hard disc, it will ask if you want to format or not. A 10GB hard
disc can be divided into 10 partitions.
• Use the Select Source to set the hard drive as the target source.
• Then select which partition to store the data in function 9 “Image.”
• If there is no data stored in partition, insert a source CD into CD-ROM and use function 9-
01 Load to transmit data from CD into selected partition by pressing ENT. Different data
can be stored in different partitions.
• Switch to the Copy function by pressing the arrow button. Insert blank CD-R or CDRW
discs into the CD writers. Press “ENT” button to start copying.
CD Duplicator
1-3 ver: 1.10B
CD Duplicator
1-7 ver: 1.10T
Initialize SDRAM.....
Detect Drives.....
1. Copy