I.R.I.S. DC1100 - Manual (Page 14)

Coaxial Networks, Inc. Page 14 of 60
IRIS Front Panel
The diagram below illustrates the front panel controls of the IRIS.
IRIS
SYSTEM
FANS,
(DON'T
BLOCK WHILE
MOUNTING)
RACK MOUNTING BRACES
(REMOVALBLE)
Cable Modem Termination System
Figure 2 IRIS Front Panel
The front panel has no indicators or controls.
1. Removable rack mounting braces for 19” rack mounting.
2. Intake openings for the system cooling fans for the IRIS chassis
Both Front panel and rear panel have vents for system fan, care should be taken that these vents
are not blocked during installation.
Mounting the IRIS Unit
The IRIS system can be mounted on a 19” Floor mounted Rack or 19” Wall Mount Rack with
other equipment. In the absence of a 19” rack, you can mount the IRIS unit flat on the wall with
the same mounting brackets supplied with the unit. The screws are provided to attach these braces
to the chassis. However you will need to provide appropriate screws to secure the chassis to the
wall. If you have a dry wall, recommended screws are hollow wall anchor screws. Always check
your local code for compliance.
Mounting on standard 19” Rack with IRIS connectors in the Front
Use the supplied screws to attach the mounting brackets to the sides of the unit in the front for
mounting IRIS on a 19” rack. Your rack supplier usually supplies the screws required for
mounting.
Mounting on standard 19” Rack with IRIS connectors in the Rear
Use the supplied screws to attach the mounting brackets to the sides of the unit in the rear for
mounting IRIS on a 19” rack. Your rack supplier usually supplies the screws required for
mounting.