I.R.I.S. DC1100 - Manual (Page 15)

Coaxial Networks, Inc. Page 15 of 60
Mounting Flat on Wall
To mount the IRIS chassis for flat wall mount use the supplied rack mounting braces and attach
them to the holes in the middle of chassis using the same screws.
IRIS
Fro
nt
Holes for Front Mounting
Holes for Rear
Mounting
Holes for Flat wall
Mounting
Figure 3 Attaching mounting braces for flat wall mount
You will need appropriate screws to secure the chassis to the wall. If you have a dry wall,
recommended screws are hollow wall anchor screws. Always check your local code for
compliance. Refer to the diagram for positioning the chassis so that sufficient air can flow in and
out of the chassis.
CHASSIS REAR
CHASSIS
FRONT
MOUNTING IRIS FLAT ON WALL
RACK MOUNT
BRACES
IRIS CHASSIS TOP
WALL ANCHOR
SCREWS, (Not
Supplied)
AIR
FLOW
AIR
FLOW
Figure 4 Flat Wall Mount
Do not mount the chassis with the chassis front of rear facing upwards. Falling debris from the
ceiling can damage the systems fans. Make sure you have sufficient room around the air ducts for