IBM Partner Pavilion iLC300 - Manual (Page 15)

Service and Support section of our website at www.ibm.com/pc/support.
computer 1 computer 2 computer 2
video
monitor network
serial control
audio in
audio in audio in audio out audio out
R
R
L
L
Y
Pr
Pb
s-video
computer in
The projector can be managed by ProjectorNet networking software through its
Network connector.
computer 1 computer 1 computer 2
video
monitor monitor network
serial control
audio in
audio in audio in audio in audio out
R
R
L
L
Y
Pr
Pb
s-video
computer in computer in
Network
Displaying a computer image
Use the following steps to display a computer image.
1.
Remove the lens cap.
2. Press the Power button on the top of the projector or the remote. The LED
flashes green and the fans start to run. When the lamp comes on, the startup
screen is displayed and the LED is steady green. It can take a minute for the
image to achieve full brightness. If you do not see a startup screen, see
Appendix B, “Troubleshooting your setup”, on page 27.
3. Turn on your computer. The computer’s image should appear on the projection
screen. If it doesn’t, press the Computer button on the projector’s keypad.
4. Make sure your laptop’s external video port is active. Many laptops do not
automatically turn on their external video port when a projector is connected.
For IBM machines, press FN+F7 to turn the external display on and off. For
other manufacturers, consult the documentation that came with your computer.
If you do not see a computer image, try pressing the Auto Image button on the
keypad.
Chapter 2. Setting up the projector 5