IBM Partner Pavilion iLC300 - Manual (Page 16)

Using the projector with Windows 98 for the first time
The first time you connect a computer running Windows 98 to the projector, the
computer recognizes the projector as “new hardware” and the Add New Hardware
Wizard appears. Follow these instructions to use the Wizard to load the correct
driver (which was installed with your Windows operating system).
If you are running Windows 2000, Windows Me, or Window XP, skip these steps
and go to “Adjusting the image”.
1.
Click Next to begin searching for the driver.
2. Make sure Search for the best driver is selected, then click Next again.
3. Uncheck any checked boxes, then click Next. Windows automatically locates
the driver. If this driver has been removed, reload the driver using your
Windows operating system CD.
4. When Windows finds the driver, you are ready to install it. Click Next.
If you connected a USB mouse cable, the Add New Hardware Wizard appears.
Drivers must be installed to use the USB functionality.
The Wizard launches three times. The first time, it detects a USB Composite
Device. The second time, it detects a USB Human Interface Device for the
keyboard. The third time, it detects a USB Human Interface Device for the mouse.
Adjusting the image
Follow these steps to adjust the image.
1.
Adjust the height of the projector, if necessary, by pressing the release button to
extend the elevator foot. Rotate the leveling foot, if necessary.
2. Position the projector the desired distance from the screen at a 90 degree angle
to the screen.
3. Adjust the zoom or focus rings by rotating them until the desired image size
and sharpness are produced.
6 IBM iLC300 Conference Projector: IBM iLC300 Conference Projector User’s Guide