IBM THINKPAD 760C/CD (9546) - Manual (Page 119)

Symptom / Error FRU / Action in Sequence
111
(I/O parity.) 1. Go to “Memory
Checkout” on
page 97.
2. Port Replicator
3. System Board
158
(HDP was not set even
though the supervisor
password is set.) 1. Set an HDP for the
hard disk drive.
159
(HDP is not set the same as
the supervisor password.) 1. Set a correct HDP for
the hard disk drive.
161
(Dead battery.) 1. Go to “Checking the
Backup Battery” on
page 103.
2. Backup Battery
3. System Board
163
(Time and Date were not
set.) 1. Set Time and Date.
2. Backup Battery
3. System Board
173
(Configuration data was
lost.) 1. Select OK in the error
screen; then set the
time and date.
2. Backup Battery
3. System Board
174
(Configuration error:
Perform “Checking the
Installed Devices List” on
page 123 before changing
any FRUs.) 1. Check Device
Configuration.
2. System Board
3. Diskette Drive
Assembly
4. Hard Disk Drive
Assembly
175, 177, 178
175 EEPROM CRC #1
error.
177 Supervisor password
check sum error.
178 EEPROM is not
functional.
1. System Board
183
(Incorrect password entered
at the supervisor password
prompt.) 1. Have the user
examine the
password.
184
(POP check sum error.) 1. Reset the POP
(power-on password)
in Easy-Setup.
185
(The startup sequence is
not valid. Suspect that
power was off when the
startup sequence was being
updated.) 1. Reset the startup
sequence in
Easy-Setup.
186 1. System Board
ThinkPad 365X, 365XD (2625) 107