JVC HR-XVC32SUJ - Manual (Page 10)

10
Component Video Connection
(For high-quality DVD pictures)
Antenna or Cable
Coaxial cable
Flat feeder
AC Outlet
Matching transformer
(not supplied)
AC Power Cord
VHF/UHF
OUT
AUDIO OUTPUT
VHF/UHF
IN
Back of unit
Audio/video
cable
(not supplied)
To Component
Video/audio Input
connector
RF cable
(supplied)
To 75 ohm Terminal
TV
COMPONENT VIDEO OUT
Component
Video cable
(not supplied)
ATTENTION
Be sure to connect the unit’s VIDEO OUTPUT (DVD/
VCR) connector to the TV’s VIDEO input connector.
~
Place the unit on a stable, horizontal surface.
Ÿ
Connect the unit to TV.
1 Connect the antenna, unit and TV as per “AV
Connection.” (☞ pg. 9)
2 Connect the unit’s COMPONENT VIDEO OUTPUT
connector to the TV’s component video input
connector.
!
Plug the end of the AC power cord into an AC outlet.
This unit performs Plug&Play Set automatically. (☞ pg.
11)
The clock and tuner channels will automatically be set
when the antenna is connected and when the AC power
cord is connected to an AC outlet for the first time. (If
“Auto” and the channel indicator are displayed on the
front display panel before the unit is powered on, the
clock and tuner channels are being set automatically.
Wait for the time to be displayed on the front display
panel before turning on the unit.)
⁄
Set the VCR channel to off.
Before performing the following steps:
• Make sure there is no cassette inserted in the unit.
• Make sure the unit is turned on, then press
VCR/DVD on the unit so that the VHS indicator lights
up on the front display panel.
1 Press POWER on the unit to turn off the unit, then
press 7 STOP on the unit for more than 5 seconds.
“3 CH” appears on the front display panel.
2 Press CH +/– on the unit to select “3 CH,” “4 CH,” or
“– CH” (off), then press POWER on the unit.
NOTES:
• By using the component video connection, you can view
the images in the progressive mode. For switching to the
progressive mode, refer to “Scan Mode Set (DVD deck
only).” (☞ pg. 11)
• To enjoy playback of DVD with the component video
connection, set the TV’s input to the component video input.
Audio cable
(not supplied)
To Audio/video
input connectors
AUDIO OUTPUT
VIDEO OUTPUT
04-11_HR-XVC32SUJ.indd 10 04-11_HR-XVC32SUJ.indd 10 05.5.12 5:08:47 PM 05.5.12 5:08:47 PM