JVC HR-XVC32SUJ - Manual (Page 21)

Operations on
DVD Deck
Advanced Operations
Additional Information
Introduction
Preparation
Operations on
VCR Deck
21
Timer Recording
Express Timer Programming
~
Select the VCR deck.
Press VCR on the Remote so that the VHS indicator
lights up on the front display panel.
Ÿ
Access the Program
screen.
Press PROG. (If you’re just
starting out, “PROGRAM 1”
appears.)
!
Enter the program
start time.
Press START +/– to enter
the time you want recording
to start.
• Press and hold START
+/– to move in 30-minute
increments, or press and release repeatedly to
move 1 minute at a time.
⁄
Enter the program stop time.
Press STOP +/– to enter the time you want recording
to stop.
• Press and hold STOP +/– to move in 30-minute
increments, or press and release repeatedly to
move 1 minute at a time.
@
Enter the program date.
Press DATE +/–.
• The current date appears on the TV screen. The
date you enter appears in its place.
¤
Enter the channel position.
Press CH +/–.
#
Set the tape speed.
Press SP/EP.
‹
Return to the normal screen.
Press PROG or ENTER. “PROGRAM COMPLETED”
appears on the TV screen for about 5 seconds, then
the normal screen appears. If “PROGRAM NOT
COMPLETED PROGRAM OVERLAP” appears on
the TV screen, see page 22.
• Repeat step Ÿ to ‹ for each additional program.
$
Engage the unit’s timer mode.
Press TIMER. The unit turns off automatically and
“
” appears on the front display panel.
• To disengage the timer mode, press TIMER again.
To Timer-Record Weekly Or Daily Serials:
— anytime during steps ! through #, press
WEEKLY (number button “9”) for weekly serials
or DAILY (number button “8”) for daily serials
(Monday – Friday). Either “WEEKLY” or “DAILY”
appears on the TV screen. Pressing the button again
makes the corresponding indication disappear.
NOTES:
• You can program this unit to timer-record as many as 8
programs. If you try to program the unit to record a ninth,
“PROGRAM FULL” appears on the TV screen. To record
the extra program, you must fi rst cancel any unnecessary
programs. (☞ pg. 22)
• Programs that start after midnight must have the next
day’s date.
Cable Box or DBS Receiver Users
To timer-record a satellite broadcast using Express
Timer Programing:
1 Perform steps ~ – $. Enter “F-1” for the
channel position in step ¤.
2 Set the DBS receiver to the appropriate
channel before the selected program begins.
3 Leave the DBS receiver’s power on.
20-23_HR-XVC32SUJ.indd 21 20-23_HR-XVC32SUJ.indd 21 05.4.21 6:31:01 PM 05.4.21 6:31:01 PM