JVC HR-XVC32SUJ - Manual (Page 35)

Additional Information
Operations on
VCR Deck
Operations on
DVD Deck
Introduction
Preparation
Advanced Operations
35
Audio Settings
DIGITAL AUDIO
OUTPUT
PCM ONLY
DOLBY DIGITAL/PCM
STREAM/PCM
Set to the appropriate mode according to the type of the device connected to DIGITAL AUDIO
OUT connector on the rear of unit.
Set this item correctly according to the logo on the device.
It is not necessary to set this mode when you connect no device to DIGITAL AUDIO OUT
connector.
PCM ONLY: Select this when connecting to a device bearing neither Dolby Digital nor
DTS logo, or a digital recorder.
DOLBY DIGITAL/PCM: Suitable for playing back a film or progressive source disc.
STREAM/PCM:
Select this when connecting an amplifier or a decoder bearing both Dolby
Digital and DTS logos.
DOWN MIX
DOLBY SURROUND
STEREO
Set to the appropriate mode according to your audio system when you play back a DVD VIDEO
disc recorded with surround multichannel audio. This setting affects only the analog audio
output signal from the AUDIO OUTPUT connectors (DVD) when playing back a DVD VIDEO
disc recorded with surround multichannel audio.
DOLBY SURROUND: Select this when you enjoy multichannel surround audio by connecting the
unit’s analog AUDIO OUTPUT connector (DVD) to a surround decoder.
STEREO: Select this when you enjoy conventional 2-channel stereo audio by
connecting the unit’s analog AUDIO OUTPUT connectors (DVD) to a stereo
amplifier/receiver or TV, or when you dub audio of a DVD VIDEO disc
recorded with surround audio to your MD, cassette, etc.
D. RANGE
COMPRESSION
AUTO
ON
You can compress the dynamic range (the difference between the loudest and quietest audio
signals) of the sound when listening to the sound at a low volume or at night.
This function is available with DVD VIDEO discs recorded with the Dolby Digital format. Set to
the appropriate mode according to the number of channels recorded.
AUTO: Audio is played back with channels other than Dolby Digital channel 1 or 2 compressed.
ON: Audio is played back with all channel compressed.
Other Settings
RESUME
ON
OFF
When this function is set to “ON,” you can use the resume function. (☞ pg. 24)
ON: The unit resumes playback from the position where playback has been stopped.
OFF: This function is deactivated.
NOTE:
This function is not available for Audio CDs and MP3 discs.
ON SCREEN GUIDE
ON
OFF
When this function is set to “ON,” the unit can display “on-screen guide” icons or characters
which shows the conditions of the unit or disc.
32-35_HR-XVC32SUJ.indd 35 32-35_HR-XVC32SUJ.indd 35 05.4.21 6:32:25 PM 05.4.21 6:32:25 PM