JVC HR-XVC32SUJ - Manual (Page 37)

Operations on
VCR Deck
Operations on
DVD Deck
Advanced Operations
Introduction
Preparation
Additional Information
37
Questions & Answers
PLAYBACK
Q. What happens if the end of the tape is reached during playback or search?
=A. The tape is automatically rewound to the beginning.
Q. During search, slow, still and frame-by-frame playback, I can’t hear any audio. What’s the
problem?
=A. This is normal.
Q. Can the unit indefi nitely remain in the still mode?
=A. No. It stops automatically after 5 minutes to protect the heads.
Q. When returning from search to normal playback, the picture is disturbed. Should I be concerned
about this?
=A. No, it is normal.
Q. Noise bar appear during search. What’s the problem?
=A. This is normal.
Q. Sometimes, during Index Search, the unit can’t fi nd the program I want to see. Why not?
=A. There may be index codes too close together.
RECORDING
Q. When I pause and then resume a recording, the end of the recording before the pause is
overlapped by the beginning of the continuation of recording. Why does this happen?
=A. This is normal. It reduces distortion at the pause and resume points.
Q. Can the unit indefi nitely remain in the Record-Pause mode?
=A. No. The unit goes to its Stop mode automatically after 5 minutes to protect the heads.
Q. What happens if the tape runs out during recording?
=A. The unit stops recording, and “ ¶
” and “
3” on the front display panel will not stop
blinking.
TIMER RECORDING
Q. “ ¶” and “ ” remain lit on the front display panel. Is there a problem?
=A. No. This is a normal condition for a timer recording in progress.
Q. Can I program the timer while I’m watching a tape or a TV broadcast?
=A. You will not see the picture as it is replaced by the on-screen menu, but the audio from
the program or tape you are viewing can be heard.
36-39_HR-XVC32SUJ.indd 37 36-39_HR-XVC32SUJ.indd 37 05.4.21 6:32:50 PM 05.4.21 6:32:50 PM