JVC GR-DVL9000 - Manual (Page 63)

EN
63
T W
Digital Dubbing
It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV
connector. Since digital signal is sent, there is little if any image or sound deterioration.
NOTES:
● You cannot use the battery pack installed in the
camcorder as the power supply since a digital
signal is output from the DV OUT connector only
when using the AC Power Adapter/Charger.
● When using the camcorder for dubbing, be sure
to use it as a player. The camcorder's DV
connector is only for output.
● If a blank portion is played back during dubbing,
an unusual image may be dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If
the above occurs, turn off power and make
connections again.
1
● The image with Fade/Wipe Effects and P.AE/
Effects is not output from the DV OUT connector.
Only the original playback image is output from
it.
1 CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
2 MAKE CONNECTIONS
Connect the camcorder to your video unit
equipped with a DV connector using the DV
cable (optional) as shown in the illustration.
3 START PLAYBACK
Press the Play button (4) to play back the
source tape.
4 START RECORDING
While watching the playback on the LCD
monitor, engage the DV connector-equipped
video unit's record mode from the spot on the
source tape you want to begin recording.
AC Power
Adapter/Charger
DC cord
Video unit equipped
with DV connector
RM-V711U
(provided)
To DV
connector
To DV OUT
connector
DV cable (optional)
PLAY
STOP
To AC outlet
Core filter
To DC IN jack
To DC OUT jack