JAI CB-141MCL - Manual (Page 33)

CM-141MCL/PMCL/RA / CB-141MCL/PMCL/-RA
30
7. Configuring the Camera
7.1 RS-232C control
All configuration of the CM-141MCL and CB-141MCL cameras is done via the RS-232C port on
the 12 pin HR connector or via Camera Link. The camera can be set up from a PC running
terminal emulator software, or using JAI's camera control software.
Below is the description of the ASCII based short command protocol.
Communication setting
Protocol.
Transmit setting to camera:
NN=  Parameter  <CR><LF> ( NN is any kind of command. Capital or small letters.)
The camera answers:
COMPLETE<CR><LF>
To have all communication visible on the emulator screen, start with:
EB=1<CR><LF>
The camera answers:
COMPLETE<CR><LF>
Transmit request command to camera:
NN?<CR><LF> (NN is any kind of command.)
The camera answers:
NN=  Parameter  <CR><LF>
Transmit the following to have the camera actual setting:
ST?<CR><LF>
The camera answers:
A complete list of the current settings
Transmit the following to have a command list:
HP?<CR><LF>
The camera answers:
A list with all commands and possible settings
Invalid parameters send to camera: (99 is an invalid parameter)
SH=99<CR><LF>
The camera answers:
02 Bad Parameters!!<CR><LF>
To see firmware number.
VN?<CR><LF>
To see camera ID. It shows the manufacturing lot number.
ID?<CR><LF>
Baud Rate 9600 bps
RS 232C cable Data Length 8 bit
Start Bit 1 bit
Stop Bit 1 bit
Parity None
Xon/Xoff Control None
TXD
RXD
GND
1 CD
4 DTR
6 DSR
2 RXD
3 TXD
5 GND
7 RTS
8 CTS
9 CI
9 pin
D-con
PC COM
PORT
CAMERA
TXD
RXD
GND
1 CD
4 DTR
6 DSR
2 RXD
3 TXD
5 GND
7 RTS
8 CTS
9 CI
9 pin
D-con
PC COM
PORT
CAMERA