JAI CB-141MCL - Manual (Page 9)

CM-141MCL/PMCL/RA / CB-141MCL/PMCL/-RA
6
4. Locations and Functions
4.1. CM-141MCL/CB-141MCL
1. Lens mount C-mount (Note *1)
2. CCD sensor 2/3 inch CCD sensor
3. 26-pin multi connector Camera Link interface(Miniature type)(Note*2)
4. 12-pin connector DC +12V power and trigger input
5. LED Indication for power and trigger
6. Mounting holes M3 depth 3.5 mm for tripod mount plate(Note*3)
*1) Note: Rear protrusion on C-mount lens must be less than 10.0mm.
*2) Note: When an Mini Camera Link cable is connected to the camera, please do not excessively
tighten screws by using a screwdriver. The Camera Link receptacle on the camera might
be damaged.
For security, the strength to tighten screws is less than 0.147 Newton meter (Nm).
Tightening by hand is sufficient in order to achieve this.
*3) Note: The tripod adapter plate MP-41 and MP-40 can be used with CM-141MCL/CB-141MCL.
MP-40 uses only two screws instead of 4.
Fig.1. CM/CB-141MCL Locations
FC
C
se
al
Se
ri
al
No
.
Ca
ut
io
n
se
al
MINI-CL
POWER/ TRIG
① ②
③
④ ⑤
⑥