Specification table – JAI CB-141MCL User Manual

Page 46

Advertising
background image

CM-141MCL/PMCL/-RA / CB-141MCL/PMCL/-RA

43

10.2. Specification table

Specifications

CM-141MCL/PMCL/-RA

CB-141MCL/PMCL/-RA

Scanning system

Progressive scan

Frame rate full frame

30.12 frames/sec. Progressive (1052 lines/frame)

Pixel clock

58 MHz

Line frequency

31.693 kHz (1H = 31.551 µs) (1830 pixel clock/line)

CCD sensor

2/3 inch Monochrome ICX285AL

2/3 inch Bayer Color ICX285AQ

Sensing area

8.98 (h) x 6.7 (v) mm 2/3 inch diagonal

Cell size

6.45 (h) x 6.45 (v)

m

Active pixels

1392 (h) x 1040 (v)

Pixels in video output.

Full Scan
2/3 partial Scan

1/2 partial Scan
1/4 partial Scan
1/8 partial Scan
Variable Partial Scan

Vertical Binning

1392 (h) x 1040 (v) 30.12 fps. H = 31.693 kHz
1392(h) x 694 (v) 41.05 fps H= 31.693 kHz
1392 (h) x 520 (v) 50.06 fps. H = 31.693 kHz
1392(h) x 260 (v) 74.57 fps. H = 31.693 kHz
1392 (h) x 130 (v) 98.73 fps. H = 31.693 kHz
Start line from 1 to 1024, height(lines) from 8 to 1032
1392 (h) x 520 (v) 50.18 fps. H = 26.447 kHz ( CM-141MCL/PMCL/-RA only))

Note: Partial scan and Vertical Binning mode cannot be used at the same time

Sensitivity on sensor (minimum)

0.03 Lux (Max. gain, Shutter OFF, 50%

video )

0.2 Lux (Max. gain, Shutter OFF,50%

Green, w/IR cut filter)

S/N ratio

More than 58 dB (0dB gain)

Digital Video output

Camera Link

8 bit, 10 bit, 12 bit

Camera Link

BAYER 8 bit, 10 bit, 12 bit

Iris video output. Analog

0.7 V p-p

Gain

Manual : -6 to +24 dB (1 Step 0.0358 dB)

Gamma

γ=1.0

Synchronization

Internal X-tal

Hardware Trigger modes

Edge Pre-Select , Pulse Width Control, RCT, Smearless EPS

Smearless mode

Available for EPS (Async)

Electronic Shutter

Preset Shutter speed

Programmable exposure

Fine Exposure

OFF(1/30) and 1/60 to 1/10,000 in 9 steps

2L(63µs) to 1052 L ( 33.19 ms) in 1L steps

1/15847 to 1/85149s (PE=2)(FE=0 to 2979)

Lens Iris Control

Video control

Control interface

Camera Link

Indicators on rear panel

Power, trigger

Operating temperature

-5

C to +50

C

Humidity

20 – 90% non-condensing

Storage temp/humidity

-25

C to +60

C/20% to 90 % non-condensing

Vibration

10G (20Hz to 200Hz, XYZ)

Shock

70G

Regulatory

CE (EN61000-6-2 and EN61000-6-3), FCC part 15 class B, RoHS, WEEE

Power

12V DC

10%. 5.1 w

Lens mount

C-mount

Rear protrusion on C-mount lens must be less than 10.0mm

Flange back

17.526mm Tolerance 0 ~ -0.05mm

Optical Low Pass Filter

Built in (Only for CB-141MCL/141MCL-RA)

Advertising
This manual is related to the following products: