Trace outline, Cancel, Edit – Janome MEMORYCRAFT 300E User Manual

Page 29: Ready to sew a z

Advertising

(5) Trace key

You can check the size of the sewing area by
pressing this key. The carriage traces the outline of
the selected embroidery pattern without stitching.
The carriage will return to the starting position after
tracing and the screen will return to the previous
display.

(6) Cancel key

Press this key to cancel the tracing and return to
the previous screen.

Screen Information
Besides the design image, approximate sewing time in
minutes, Number of colors, design size and the hoop
that should be used for the selected design are shown.

1 Sewing time in minutes
2 Number of colors
3 Design size
4 Hoop

(7) Stitch Back/Forward keys

When embroidery sewing has started, the screen
will indicate the current stitch counts. The Jog keys
will disappear and the stitch back/forward keys will
be indicated on the screen. You can use these
keys to move the embroidery hoop to where the
thread has broken or run out.

Press the Minus key to move the hoop back to a
previous sewing point. The hoop will move backward
every 10 stitches when you press this key.
Press the Plus key to move the hoop ahead. The
hoop will move forward every 10 stitches when you
press this key.

(8) Jog/ST key

Press this key to switch the jog keys to the stitch
back/forward keys before sewing.

(9) Return Carriage Key

Press the return carriage key to bring the carriage
back to its stored position after finishing
embroidery.

NOTE:
Before you turn the power switch OFF in Embroidery
mode, always be sure to press the return carriage key
to return the carriage to its stored position.

Edit

Mode

Ready to Sew

A Z

Size

A(F): 126x110mm

76x62mm

13 Colors

22 min

Jog

Bamboo

Toast

Hazel

Brown

224

255

254

214

(5)

Trace outline

Cancel

(6)