JVC RS-WP1WT - Manual (Page 23)

English
20
Action
• Check all connections and make corrections.
(See page 4.)
• Disconnect the headphones.
Cover the holes on the back edge of the cassette
with tape.
Fully extend the FM telescopic antenna and turn it
for the best reception.
Clean or replace the CD.
Put the CD in with the label side up.
• Remove the obstruction.
• Replace the batteries.
Unplug the System then plug it back in after a few
minutes.
Plug in the AC adaptor and press the
STANDBY/ON button.
Possible Cause
• Connections are incorrect, or loose.
• Headphones are connected.
Cassette record protect tabs are removed.
The FM telescopic antenna is not properly
extended and positioned.
The CD is dirty or scratched.
The CD is upside down.
• The path between the Remote Control and the
sensor on the Unit is blocked.
• The batteries have lost their charge.
The built-in microprocessor has malfunctioned
due to external electrical interference.
During tape playing, the AC adaptor was
unplugged.
Symptom
No sound is heard.
Unable to record.
Poor FM reception
The CD skips.
The CD does not play.
Unable to operate the Remote Control.
Operations are disabled.
The cassette holder cannot be opened.
Troubleshooting
• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.