Connecting the ac adaptor cord, How to operate the system on batteries, English 5 – JVC RS-WP1WT User Manual
Page 8
English
5
“R20/D (13F)” size batteries
Connecting the AC Adaptor Cord
Firmly insert the supplied AC adaptor cord into the DC IN jack on the back of the System.
DC IN
12V
AC adaptor cord
To wall outlet
Note:
This Unit may generate noise depending on the positioning of the AC adaptor.
Place the Unit and AC adaptor as shown in the figure.
Notes:
•
When you operate the System on AC power or car battery (DC12V), the power source automatically switches from batteries to AC or
DC12V. However, you should remove the 8 batteries when operating on AC power or car battery (DC12V).
•
When the batteries are exhausted, mistracking will occur during CD playback or sound will be distorted intermittently during tape
playback. You need to replace the batteries at a time.
•
It is recommended that the AC adaptor be used when recording important material or listening to a CD.
•
When inserting batteries in the System, lay it on a soft surface so as not to damage it and facilitate insertion.
CAUTION: Handle batteries properly.
To avoid battery leakage or explosion:
•
Remove 8 batteries when the System will not be used for a long time.
•
When you need to replace the batteries, replace all batteries at the same time with new ones.
•
Don’t use an old battery with new ones.
•
Don’t use different types of batteries together.
CAUTIONS:
•
ONLY USE THE JVC AC ADAPTOR PROVIDED WITH THIS SYSTEM TO AVOID MALFUNCTION OR
DAMAGE TO THE SYSTEM.
•
BE SURE TO UNPLUG THE AC ADAPTOR FROM THE OUTLET WHEN GOING OUT OR WHEN THE
SYSTEM IS NOT IN USE FOR AN EXTENDED PERIOD OF TIME.
Now you can plug the AC adaptor into the wall outlet, and your System is at your command!!
How To Operate the System on Batteries
You can operate the System on 8 batteries.
1. Open the battery cover on the back of the System by pulling it toward you while pressing the tab.
2. Put 8 batteries (not supplied) in the battery compartment.
•
Match the polarity (+ and –) on the batteries with the + and – marking in the battery compartment.
3. Securely close the battery cover while pressing the tab.