Jotul GF 200 DV - Manual (Page 13)

13
Wall Shield Installation
When horizontally venting directly off the rear of the
stove, install the decorative Wall Shield #129349,
(included in the stove), to cover the top of the
venting hole in the wall. See Figure 14.
1. Remove the top four 1/4” hex head screw from the
rear shroud of the stove.
2. Align the holes in the wall shield with the holes in
the rear shroud.
3. Secure the wall shield to the stove with the four
1/4” hex head screws.
Figure 13. Termination clearances to exterior overhangs.
Rear
Shroud
Wall Shield
Figure 14. Install the Wall Shield.
18” Max.
460 mm
Simpson Dura-Vent
Horizontal Termination
Cap #984 or #985
6” (150 mm)
Simpson Dura-Vent
#908B
Two 90 Degree
Elbows
OPTION # 5
Figure 12-5. Horizontal vent with two elbows.
OPTION # 4
Figure 12-4. Maximum horizontal run with single
elbow to a snorkel termination.
3”
76 mm
12 ”
305
mm
2 1/2”
64 mm
Two Simpson
Dura-Vent 90
Degree Elbows
#990B
Simpson Dura-Vent Wall
Thimble Cover #940
Simpson Dura-
Vent Horizontal
Square
Termination
#984
Figure 12-5a. Horizontal vent with two elbows.
OPTION # 5
Simpson Dura-Vent
14” Snorkel #982
Simpson Dura-Vent 45
Degree Elbow #945
12” (300 mm) and 6” (150 mm)
Max. Horizontal Run
into a 14” Snorkel
Both Draft Restrictors Required