Jotul GF 200 DV - Manual (Page 5)

5
DO NOT OPERATE THE LILLEHAMMER
GAS STOVE WITH THE GLASS FRONT
REMOVED, CRACKED OR BROKEN.
REPLACEMENT OF THE GLASS SHOULD
BE DONE BY A LICENSED OR QUALIFIED
SERVICE PERSON. ONLY REMOVE
GLASS FOR ROUTINE SERVICE.
ALWAYS HANDLE GLASS CAREFULLY.
SEE THE MAINTENANCE CHAPTER FOR
INSTRUCTIONS ON REPLACING THE
GLASS PANEL.
General Information
n
THIS HEATER MUST BE INSTALLED AND MAIN-
TAINED BY A QUALIFIED SERVICE AGENCY.
n
THIS APPLIANCE MUST NOT BE CONNECTED TO A
CHIMNEY OR FLUE SERVING ANY OTHER APPLI-
ANCE.
n
The installation and repair of this appliance must
be done by a qualified service person. Failure to
properly install and maintain this heater could
result in an unsafe or hazardous installation,
which may result in a fire, explosion, property
damage, personal injury or loss of life.
n
This appliance should be inspected before use and
at least annually. More frequent cleaning may be
required due to excessive lint from carpeting,
bedding material, etc. It is imperative that control
compartments, burners, and circulating air
passageways of the appliance be kept clean.
n
The installation must conform to local codes. Your
local Jøtul dealer can assist you in determining
what is required in your area for a safe and legal
installation. Some areas require a permit to install
a gas burning appliance. Always consult your
local building inspector, or authority having
jurisdiction, to determine what regulations apply
in your area.
n
REMEMBER: Your local officials have final author-
ity in determining if a proposed installation is
acceptable. Any requirement that is requested by
the local authority having jurisdiction, that is not
specifically addressed in THIS manual, defaults to
local code. In the absence of local codes, the
installation requirements must comply with the
current National codes. In the U.S., these require-
ments are established in the National Fuel Code,
ANSI Z223.1.(NFPA 54). In Canada, the codes have
been established in CAN/CGA B149 Fuel Installa-
tion Code.
n
Installer l’appareil selon les codes ou reglements
locaux, ou, en l’absence de tels reglements, selon
les Codes d’installation CAN/CGA-B149.
n
DO NOT OPERATE THIS STOVE IF ANY PART HAS
BEEN UNDER WATER. Call a qualified service
technician to inspect the heater and to replace
any part of the control system and any gas control
which may have been under water.
n
Ne pas se servir de cet appareil s’il a ete’ plonge
dans l’eau, completement ou en partie. Appeler
un technicien qualifie pour inspecter l’appareil et
remplacer toute partie du syste’me de controle et
toute commande qui ont ete plonges dans l’eau.
Glass Panel