JVC TV 20240 - Manual (Page 10)

9 G E T T I N G S T A R T E D
CHANGING CHANNELS
10 key direct access.
Press the numbers on the remote’s 10 key pad. For single-digit channel numbers press 0 then the
number. For channels above 100, press the 100+ button plus the 2-digit number.
C HANNEL –/+ button.
Press the C HANNEL –/+ button, to scan the channels in order.
❒ After you operate the Auto Tuner Setup (page 12), all of the blank, or empty, channels will be re m o v e d
f rom scanning so that there is no noise or channel snow when you scan, only active channels.
Return.
Press the R ETURN button to return to the previous channel. First, select a channel
(game #1). Then, select another channel (game #2) with the 10 key pad and push the R ETURN button
to flip directly back and forth.
1
2
3
❒ Press the P
OWER button on the remote control or the TV/VCR combo front panel. The On Timer
lamp will glow red.
❒ Make sure that the TV/CATV switch on the remote is set to TV. Switch to CATV only if you plan to
operate a cable box. If you switch to CATV you will not be able to operate the TV/VCR combo
functions with the remote, only the cable box functions!
❒ To turn the power off, press the P
OWER button again. The On Timer lamp will go out.
❒ The On Timer lamp will glow green when the On/Off Timer is set to yes, even when the TV power
is off.
POWER
Adjust the volume with the V OLUME –/+ buttons on the TV/VCR combo front panel or on the
remote control. Press the V OLUME – button to lower the volume. Press the V OLUME + button to
raise the volume.
Press the M UTING button to instantly turn the volume off to zero. To restore the volume to the
previous volume level, simply press the M UTING button again.
ADJUSTING VOLUME
VOLUME 13
|||||||
-------------------
1
2