JVC TV 20240 - Manual (Page 23)

V C R P L U S
+
2 2
VCR PLUS+
Your TV/VCR Combo comes
equipped with VCR Plus+ technolo-
gy. This function allows you to
program your VCR simply by
entering the VCR Plus+ code number
associated with the program you
wish to record.
Note: Before VCR Plus+ can be
used, VCR Plus guide channels must
be programmed. See VCR Plus
Guide Setup in “Initial Setup” page
14, if you have not yet programmed
these channels).
TIMER RECORDING WITH VCR
PLUS+
Press the VCR PLUS + button
on the remote control
The VCR PLUS + code screen appears
Enter the VCR PLUS + code (three-to-
eight digit number) of the show you
wish to record using the 10-key pad
on the remote control. The following
screen will appear:
Note: If you enter the VCR Plus +
code incorrectly, press C ANCEL on the
remote. The first screen will
reappear.
Press the D AILY /W EEKLY
button to select how often a
program should be recorded,
ONCE, DAILY, or WEEKLY
Press the SP/EP button to
select SP or EP recording
speed. (See pg 20 for more
on tape recording speeds)
Press the VCR P
LUS + button
The following screen will appear,
displaying a summary of the informa-
tion you just entered:
If the settings are correct, press the
VCR P
LUS + button again to accept. The
following message will appear:
If you wish to make a correction, use
the (
) buttons to move to the item
and the ( ) buttons to correct. Once
corrected press VCR P LUS + to accept
the settings.
Press the Timer button
on the remote control.The timer
is now in standby mode.
The REC lamp will glow green on the
front panel of the unit, indicating the
timer has been programmed. When the
programmed start time arrives, the
REC lamp will glow red and recording
will begin. When the programmed stop
time arrives, the lamp will go out and
the recording will automatically stop. If
there are other pre-set recordings the
REC lamp will glow green.
NOTES:
V C R P l u s +
C o d e s
VCR Plus codes for
individual pro g r a m s
may be found in
most local newspa-
per television
listings or in TV
magazines. VCR
Plus+ Codes are th
t h ree to eight digit
number usually
shown after the title
or description of a
p rogram in TV
l i s t i n g s .
You can pro g r a m
your VCR with up to
six events. These
events may be up t
a month in the
f u t u re. For more
i n f o rmation on
setting timer re c o rd
ings, see "Regular
V C R P ro g r a m m i n g "
on page 20.
Note:
VCR Plus+ and
PlusCode are
registered
trademarks of
Gemstar
Development
Corporation.
The VCR Plus+
system is manufac-
tured under license
from Gemstar
Development
Corporation.
- - - - - - - -
ENTER THE PLUS CODE
1234
HOW OFTEN?
ONCE DAILY (M-F) WEEKLY
SELECT
RECORDING SPEED SP EP
IF ALL OK, CANCEL BY
PUSH VCR PLUS+ CANCEL
DATE MON - FRI
START 2:30 PM
STOP 3:00 PM
CHANNEL 03
RECORDING SPEED SP EP
IF ALL OK, CANCEL BY
PUSH VCR PLUS+ CANCEL
YOUR PROGRAM IS CONFIRMED
PUSH THE TIMER BUTTON